NTP Time Synchronization
Network Time Protocol, or NTP, enables a device to synchronize its clock with a time reference over an IP network. It uses timestamped messages to estimate the difference between the device’s local time and the server’s time.
NTP synchronization is a repeated measurement process. The client gathers timing observations and uses them to control its clock as network conditions and oscillator behavior change.
How an NTP Exchange Works
In a typical client-server exchange, the client sends a request and the server returns timing information. Timestamps recorded at both ends allow the client to estimate clock offset and round-trip delay.
The server’s processing interval can be separated from the overall exchange. However, unequal outward and return network delays can still introduce error into the offset estimate.
An NTP response therefore provides a timing observation rather than an instruction to copy the server’s displayed time at the moment the packet arrives.
Why NTP Uses Repeated Measurements
Network packets do not always experience the same delay. Queueing, changing traffic conditions and device processing can produce variation between successive exchanges.
An NTP implementation can filter observations and evaluate available sources before adjusting the local clock. This reduces the influence of individual measurements affected by unusual delay.
Three useful measurements are:
| Measurement | Meaning |
|---|---|
| Offset | Estimated difference between the local clock and the reference |
| Delay | Estimated round-trip communication time |
| Jitter | Variation in timing observations |
Repeated observations also help the client distinguish an initial time error from an ongoing difference in clock rate.
What NTP Stratum Means
Stratum describes a server’s position in the synchronization hierarchy.
A stratum 1 server is directly connected to a primary time reference. A server synchronized through a stratum 1 server normally operates at stratum 2, with further levels following the same principle.
Stratum is not an accuracy specification. A lower stratum does not automatically mean a particular client receives more accurate time, because the communication path and implementation also affect the result.
How the Local Clock Is Corrected
Clock-control software may correct time by making an immediate adjustment or by gradually changing the clock’s rate.
Step
An immediate adjustment is often called a step.
Slewing
A gradual adjustment is commonly called slewing. The method depends on the implementation, the size of the error and the device’s operating state.
Frequency Correction
After initial synchronization, continued frequency correction helps the clock remain aligned between updates.
NTP and SNTP Behavior
Simple Network Time Protocol, or SNTP, uses a compatible timing-message format with a simpler implementation.
An SNTP device may obtain time successfully without implementing the full source-selection, filtering and clock-discipline behavior associated with a more complete NTP client. Identical server addresses therefore do not imply identical timing performance across different receiving devices.
Network Time and Displayed Local Time
NTP distributes time referenced to UTC. Time-zone offsets and daylight-saving rules are applied separately by the receiving device or its display software.
A clock can consequently have a correct synchronized time base while showing an incorrect local hour if its regional settings are wrong. Synchronization and local-time conversion are separate operations.
Does an NTP wall clock need access to the public Internet?
No public Internet connection is inherently required when the clock can reach a suitable approved NTP source on the local network. Confirm the selected clock’s supported configuration, server access and behavior if the reference becomes unavailable.
For broader planning questions, see our synchronized clock FAQs.
NTP Clock Systems from HC Electronics
HC Electronics supplies NTP time servers and network-synchronized clocks for facilities that require a consistent time base across every display. Share your network layout and clock requirements, and our engineers will recommend a suitable configuration. For multiple displays, review how to plan an NTP clock system.
Learn more about HC Electronics or visit our contact page.